Back to the front and rear axle Fitting the body I To the dashboard I
Side panels
[Enlarge] 		Just tilt the box on a side and fitting the side panels is as simple as possible. At this point the problem of fastening the bottom panels on the outer side too early returns: The side panels get a real nice wavy "design" on the lower side.
Side panels.
[Enlarge] 		The same situation seen from the front. Filling the waves on the bottom cost another load of silicone. I don't want any water to get inside the car (at least from below :) ).
Tail view.
[Enlarge] 		It almost looks like a seven from behind! These little successes always give me a lot of motivation to go on. Wiring the lights took me a long time. I need to solder the wires into the connectors, because I never got these crimping connecters to work successfully otherwise.
Rear wing fitting.
[Enlarge] 		I also put the fuel tank in to test if it really fits. In the background you can see my artwork for fastening the wings. If that one falls off, I don't know why.
Back to the front and rear axle To the dashboard I